User's Manual

Chapter 2: Installing the Access Point
28
Unpacking the AT-TQ4600 Access Point
As you unpack the access point, check the shipping container for the
components the following items:
 One AT-TQ4600 Wireless Access Point
 One AT-TQ4600 Wireless Access Point Quick Install Guide
 Four rubber feet with one mounting-bracket screw
 One bracket for wall or ceiling mounting
If any item is missing or damaged, contact your Allied Telesis sales
representative for assistance.
If you are not using the PoE feature on the LAN port of the access point to
power the device, you need to separately order the AT-TQ0091 AC/DC
Power Adapter. The adapter comes with four regional AC plugs. (One of
the AC plugs comes pre-installed on the adapter.) Refer to Figure 2.
Figure 2. AT-TQ0091 AC/DC Power Adapter
Do one of the following:
 To install the unit on a table, go to “Installing the Access Point on a
Table” on page 29.
 To install the unit on a wall or ceiling, go to “Installing the Access
Point on a Wall or Ceiling” on page 33.
Draft 9-23-14