User's Manual

AT-TQ4600 Wireless Access Point Installation Guide
31
Figure 5. Connecting the Power Cable from the AT-TQ0091 AC/DC
Adapter
8. Check the AC plug on the AC/DC Power Adapter to see if it is the
correct plug for your region. If it is not the correct plug, remove it by
pushing down on the release tab and sliding it from the slot on the
adapter. Refer to Figure 6.
Figure 6. Removing an AC Plug from the AT-TQ0091 AC/DC Power
Adapter
9. Slide the correct AC plug for your region into the slot on the adapter
until it clicks into place. Refer to Figure 7 on page 32.
Release Tab
Draft 9-23-14