Installation manual

Configuring with CardAssistant
13
1. Launch CardAssistant. If your primary operating system
is Windows 3.x, Windows for Workgroups 3.x, Windows
NT 3.1, or DOS, run the DOS version of CardAssistant. See
“Running CardAssistant in DOS Mode” on page 10. If your
primary operating system is Windows 95 or Windows NT
3.5x, run the 32-bit Windows version of CardAssistant. See
“Running CardAssistant in 32-bit Windows Mode” on
page 11.
2. Choose “Configure I/O Parameters” or “Auto Configure”
from the main menu. “Configure I/O Parameters” displays
the card’s current settings. “Auto Configure” proposes
settings for you. Check the settings that are proposed, and,
if necessary, select alternate settings from Table 3.
3. You can use the mouse or arrow keys to select the settings
to be modified.
4. Press and a pop-up menu displays the choices for the
resource you have selected.
5. When you have chosen the setting you want, press .
Table 3: I/O Configuration Settings
Resource Default Alternate Settings
Base I/O Address 300h 220h through 3E0h at 20h intervals
Interrupt Level 15 3, 4, 5, 9, 10, 11, 12
DMA Channel 7 3, 5, 6
Port Selection Autoselect UTP; optionally BNC, AUI, or Fiber
Plug and Play Enabled Disabled
Full Duplex Disabled Enabled
ENTER
ENTER