Installation manual

Configuring with CardAssistant
15
NOTE
Diagnostics runs in DOS mode with no drivers loaded.
comment out the driver line in the batch file (for NetWare) or
the
DEVICE=drivername
line in
config.sys
(for an NDIS
driver) and restart the PC.
1. Boot the computer into DOS. Launch CardAssistant by
typing:
<drive> :setup15
where
<drive>
is the diskette drive containing the
CardAssistant program.
2. Select the Diagnostics menu by typing: d .
The diagnostic routines display whether the card passed each
test and report possible causes of any failures.
Running CardAssistant in Command-Line Mode
When you wish to prepare and configure several AT-1500 Plug
and Play cards for users in an assembly-line approach, you can
either use configuration parameters in the command line or you
can write a (
.bat
) file that invokes CardAssistant when read.
The syntax for running CardAssistant in batch mode (from DOS)
is as follows:
setup15 [
IOBase
] [
parameters
]
where IOBase is the base hexadecimal I/O address of the adapter
(e.g., 300), and
parameters
is replaced with the parameters you
wish to modify from their default values. If you intend to use the
default value for a parameter, it may be omitted.
ENTER
ENTER