Installation manual

AT-1500 Plug and Play
16
Table 4 lists the parameters that may be set.
With the exception of
/CW
,
/CR
,
/E
,
/M
, and
/X
, parameters may be
combined on the command line.
Here are sample command lines for differing requirements:
setup15 0x300 /I15 /D5 /UTP
setup15 320h /I5 /D6 /Fiber
setup15 /CR
adapcard.prm
NOTE 1. For the range of values, refer to Table 3 on page 13.
NOTE 2. Specialized parameter is used by itself.
Table 4: Command-Line Mode Parameter Names
Parameter Function
/I
x
x
= interrupt level
1
/D
x
x
= DMA channel
1
/UTP
selects the UTP (10BASE-T) port
/BNC
selects the BNC port
/FIBER
selects the Fiber Optic port
/AUI
selects the AUI port
/AUTO
configures for automatic port selection
/E
returns the number of AT-1500 Plug and Plays installed
2
/M
invokes CardAssistant in monochrome mode
2
/X
performs diagnostics
2
/CW
filename writes configuration file
/CR
filename reads configuration file