Installation manual

Configuring with CardAssistant
19
When configuring cards using command-line parameters,
setup15 can configure only one AT-1500 Plug and Play card at a
time. If multiple boards are to be installed, either run
CardAssistant interactively, or use a configuration file.
NOTE
CardAssistant counts cards when it runs. This count correlates
to the “board instance” parameter in the configuration file. The
cards are counted by base I/O address in descending order
(from the highest address to the lowest).
e.g. "setup15 /CW file.nam ".
Comment lines are preceded by "//".
SAMPLE CARD CONFIGURATION FILE
------------------------------
//
// Configuration file for ATI AT-1500
// network adapter card
//
// Board instance
1
// Base IO Address
300h
// Interrupt
3
// DMA
6
// Media selection
Twisted Pair
// Boot PROM
DISABLE
Reconfiguring a Previously Installed Card
If the card is working properly but you wish to reconfigure some
of the I/O resources, you must first override the Plug and Play
feature. See “I/O Resources in Non Plug and Play Installation”
on page 9. When you launch CardAssistant, the configuration
window shows the current settings for the card(s) installed.