Installation manual

Troubleshooting
33
To determine base I/O address and interrupt
If the CardAssistant program does not detect the presence of the
card, the address may be in a range that conflicts with another
device on the bus. In this case, the only way to access the card is
to change the base address setting of one device or the other.
Either remove other card-cage peripherals that might have the
same I/O address or move the AT-1500 Plug and Play to another
computer.
If the card passes diagnostics, try reconnecting the computer to
the network and running diagnostics again. This time a failure
may be caused by physical medium connections or by corrupted
network software. You can test the connectors, terminators and
cables by swapping them for known good ones.
7 LPT1; data acquisition, voice comm. adapter
8 Real-time clock interrupt
9 EGA/VGA
10 Reserved
11 Reserved
12 Reserved
13 Coprocessor
14 Hard disk controller
15 Reserved
Table 9: Some Typical Device Uses of Bus Resources (Continued)
This
resource...
may be used for...