Installation manual

AT-1500 Plug and Play
2
Your computer must be an IBM-PC or compatible computer with
the following specifications:
❑ ISA bus (or EISA bus) computer with 16-bit slot available
that supports bus mastering
❑ Compatible operating system such as Windows 95,
Windows NT, Windows for Workgroups, Windows 3.x,
DOS, or OS/2
❑ Approximately 32K of available RAM, depending on the
driver installed
❑ 512K of available RAM when running Allied Telesyn
CardAssistant setup/diagnostics software
❑ A free 32-byte block of I/O between 220 and 3FF
❑ An available interrupt (IRQ 3, 4, 5, 9, 10, 11, 12, or 15)
❑ An available DMA channel (3, 5, 6, or 7)
The Allied Telesyn CardAssistant
The Allied Telesyn CardAssistant configuration and diagnostic
diskette has the software you need for setting up the
AT-1500 Plug and Play card with many different network
software packages. The diskette includes:
❑ CardAssistant setup and diagnostic test programs
Network adapter card drivers
• ODI drivers for use with a workstation on a Novell
NetWare network
• NDIS drivers for Microsoft Windows 95, Windows NT,
Windows for Workgroups, or TCP/IP
• A packet driver for TCP/IP
• ODI and NDIS drivers for servers.
❑ Support files for network software
❑ readme files