User manual

AT-1720
10
Saving configuration to system partition
1. Boot your computer as in “Installing option files” Steps 1a
or 1b, on page 7.
2. In the Main Menu, select the “
Set Configuration ” menu.
3. To backup the configuration you just completed, select
“
Set configuration
,” and from that menu, select
“
Backup configuration
.” When the backup is complete (a
few seconds) press to accept the backup, to go to
the Main Menu, and to exit.
If the installation has been successful up to this point, go to
Chapter 3, “Network Adapter Card Drivers.” If you experience
difficulties, and need to run card diagnostics or view
configuration parameters, invoke the CardAssistant program.
Invoking CardAssistant
The CardAssistant software may not be used to
modify adapter card parameters. To change these
parameters, you must use your computer
manufacturer’s configuration software.
1. Insert the installation diskette into the appropriate floppy
drive.
2. Type:
floppydrive :\setup17
where floppydrive is the disk drive containing the
CardAssistant program. Proceed to Step 4.
ENTER F3
F3
N
ot
e