User`s guide

Operating and Managing the FORMULA 8200 Switch

4-6

Configuring Ethernet Port Settings

Note

You cannot configure FX ports. They are fixed at 100 Mbps, full

duplex.

You can conﬁgure the following parameters for TX ports:

❑ Autonegotiation

❑ Port speed

❑ Port duplex

To configure Ethernet port parameters:

1. Use the

ETHERNET/CONFIG/PORT command.

2. Enter new conﬁgurations, or accept the defaults.

For example, if the screen shows autonegotiation as being

disabled (

N), and you want to keep it disabled, enter N again.

Otherwise, if you just press Enter, the autonegotiation reverts

to the default setting as enabled (

Y).

/ETHERNET/CONFIG/PORT

Ethernet Port Configuration

(Press <Return> to take default value, Q to Quit)

Enter port(s) number to configure (1..16) (<port#-port#>):1 2 3

Autonegotiation enable? (y/n) (default=y):N

Port speed (1=10MBPS, 2=100MBPS) (default=100MBPS):1

Half duplex/Full duplex (1=Half, 2=Full) (default=Half):1

Transmission enable? (y/n) (default=y):Y

Receiving enable? (y/n) (default=y): Y

Enter (S=save, Q=quit): S