User`s guide

FORMULA 8200 User’s Guide
4-27
Modifying the IP RIP Mode
This section shows you how to modify the IP RIP mode once a VLAN
has been created. You can set the RIP mode to one of four available
states:
❑ Active (a) - to send and receive RIP packets
❑ Deaf (d) - to send only
❑ Inactive (i) - to disable RIP
❑ Silent (s) - to receive only
In the example below, the initial mode is silent and is modified to
active. Use the same procedure to change the mode to any other
state.
To modify the IP RIP mode:
1. Enter the
VLAN/CONFIG/MODIFY <VLAN#> command.
The following display appears:
2. Set RIP mode to Active by entering the following at the prompt:
9=A
3. Confirm the change by entering 0 at the prompt:
Enter selection (0 to commit, c to cancel) >
0
VLAN Modification :
VLAN 3 Configuration Parameters Current Value
------------------------------------------------------
1) VLAN ID :- 3
2) Description :- VLAN 3
3) VLAN enabled :- Y
4) IP enabled :- Y
5) Network Address : - 192.18.31.200
6) Subnetwork Mask :- 255.255.255.0
7) Broadcast Address : - 192.18.31.255
8) Router Description :- Router for VLAN 3
9) IP RIP Mode (Active(a), Silent(s), Deaf(d), Inactive(i)) : -
Silent
------------------------------------------------------
Modification instruction :
usage: <number of parameter> = <new vlaue>
command example: 2 = Engineering VLAN(#1)
---------------------------------------------
Enter selection (0 to commit, c to cancel) >