Specifications

Introduction
Bonito Technical Manual V2.2.1
7
continued from last page
V2.2.0 03.05.12 Added description of new features in camera firmware V1.0.7
• Changed max. current from 0.36 A to 0.4 A:
– Description to power supply: see Chapter Bonito CL-
400B/C, Bonito CL-400B/C 200fps on page 12
–Chapter Accessories on page 20
–Chapter Power supply (pin 1-4) on page 23
• Pin 6 changed from Reserve to Sync:
see Chapter Camera I/O connector pin assignment (15-pin
D-Sub jack) on page 23ff.
•Chapter Synchronization output (pin 6) on page 24
• In Chapter Exposure output (pin 12-13) on page 25: added
Note This output is not recommended for new system
designs. on page 26.
• Added Chapter Synchronization output (J) on page 39
• Updated the following chapter to new bit field order:
Chapter Exposure control mode (M) on page 40
• Range from N=0 (not N=1) in Chapter Number of lines (N)
on page 46
• Added values 5 and 7 in Chapter Camera Link output mode
setting (S) on page 47
• In Chapter Reset to factory defaults (Z) on page 51:
Corrected E=000006BE (not 000006C1),
F=000006BF (not 000006C2)
Inserted J=01 and S=00
• Added new command reference description in Chapter
Command reference on page 56
• Added hyperlink to AVT website for DeviceConfig in Chapter
Serial I/O on page 20
• Changed AOI to ROI in the whole manual
to be continued on next page
Version Date Remarks
Table 1: Document history