Specifications

Specifications
Bigeye Technical Manual V2.3.0
16
Note

The design and specifications for the products described above
may change without notice.
Note

The right polarization of the 12 V supply voltage has to be
taken into consideration.
The two hexagon socket screws (M 5) in the front plate must
not be loosened in any case since this may cause a leak to the
vacuum area.
Caution

Surge
To avoid damage caused by surge, connect the camera to an
AC/DC power supply. Use a certified industrial power supply
that complies with common industrial standards. Make sure
the polarization of the power supply is correct.
During the camera start-up, inrush currents ≥ 4 A can occur for
20 ms. Use a sufficiently dimensioned power supply to avoid
damage to the camera.
For the DC signal, use cable lengths less than 30 m. Consider
that the voltage drop increases with the cable length.
AVT (or your local dealer) provides suitable power supplies:
http://www.alliedvisiontec.com/emea/products/
accessories.html