Specifications

Camera interfaces
Bigeye Technical Manual V2.3.0
34
Power supply (pin 1-4)
Bigeye P-132B/C (NIR) Cool
The camera requires 12 V +5% at a current capacity of maximum 2.8 A.
After attaining the end cooling temperature (- 20 °C) the current capacity goes
down to approx. 1.1 - 1.5 A. The exact value also depends on the ambient tem-
perature of the camera.
Bigeye P-629B/C (NIR) Cool
The camera requires 12 V +5% at a current capacity of maximum 2.8 A.
After attaining the end cooling temperature (+5 °C) the current capacity goes
down to approx. 0.8 - 1.2 A. The exact value also depends on the ambient tem-
perature of the camera.
Bigeye P-1100B/C Cool
The camera requires 12 V +5% at a current capacity of maximum 3.0 A.
After attaining the end cooling temperature (0 °C) the current capacity goes
down to approx. 1.2 - 1.6 A. The exact value also depends on the ambient tem-
perature of the camera.
3
External
GND
GND External Ground
4
5--- Reserved
6--- Reserved
7 RXD In RS232 Serial control
8 TXD Out RS232 Serial control
9 Mode input + 12V, 20 mA max. Internal pull-up resistor
10
Trigger input
-
12V, 20 mA max. Optocoupler input
11 +
12
Exposure
output
-
12V, 20 mA max. Optocoupler output
13 +
14 Line-sync
output
Out 5 V (at no load) Active low
15 Frame-sync
output
Out 5 V (at no load) Active low
Pin Signal Direction Level Description
Table 13: Camera I/O connector pin assignment (Bigeye P-1100B/C Cool)