Technical information

AVT GigE camera attributes

AVT GigE Camera and Driver Attributes V1.3.1

This document is a master document for all AVT GigE camera models and is NOT camera specific

ThresholdPWL1 – Integer – R/W

Valid only when ExposureMode = PieceWiseLinearHDR. The first and highest

threshold level in PieceWiseLinearHDR. 0 = no light capacity, 63 = full pixel light

capacity.

ThresholdPWL2 – Integer – R/W

Valid only when ExposureMode = PieceWiseLinearHDR. The second and lowest

threshold level in PieceWiseLinearHDR. 0 = no light capacity, 63 = full pixel light

capacity.

Shutter – Enum – R/W

Activate or deactivate the mechanical shutter of Bigeye G-629B Cool cameras.

Range: [0–63] Default: 63

Note



Leaving ThresholdPWL1 at 63 disables the first threshold of

PieceWiseLinearHDR mode, effectively disabling HDR mode.

Range: [0–63] Default: 63

Note



Setting ThresholdPWL2 above ThresholdPWL1 disables the

second threshold of PieceWiseLinearHDR mode.

Off Deactivate the mechanical shutter. Use this mode, if you operate

the camera with pulsed light sources

On [Default] Activate the mechanical shutter. If activated, the

mechanical shutter opens upon each exposure cycle and closes

again, when the exposure is over. Use this mode, if you operate the

camera with constant light sources, due to the full frame sensor

SyncIn1 Enables or disables the mechanical shutter dependent on the level

of SyncIn1

SyncIn2 Enables or disables the mechanical shutter dependent on the level

of SyncIn2

SyncIn3 Enables or disables the mechanical shutter dependent on the level

of SyncIn3

SyncIn4 Enables or disables the mechanical shutter dependent on the level

of SyncIn4

SyncIn5 Enables or disables the mechanical shutter dependent on the level

of SyncIn5

Note



The shutter feature is intended to control the exposure by

means of a mechanical shutter. It should not be confused with

any other exposure control feature.

The mechanical shutter is available ONLY on the Bigeye G-629B

Cool camera.