Technical information

AVT GigE camera attributes

AVT GigE Camera and Driver Attributes V1.3.1

This document is a master document for all AVT GigE camera models and is NOT camera specific

EventNotification – Enum – R/W

Default: Off. Turns the selected event notification On or Off.

EventSelector – Enum – R/W

Select a specific event to be enabled or disabled using EventNotification. Pos-

sible values:

EventsEnable1 – Uint32 – R/W

Default: 0. Bit field of all events. Bits correspond to last two digits of EventID.

For example, Bit 1 is EventAcquisitionStart, Bit 2 is EventAcquisitionEnd, and

Bit 10 is EventSyncIn1Rise. This is an alternative to setting each event individ-

ually using the EventNotification and EventSelector method.

EventSyncIn1Fall – Uint32 – R/C 40011

EventSyncIn2Rise – Uint32 – R/C 40012

EventSyncIn2Fall – Uint32 – R/C 40013

EventSyncIn3Rise – Uint32 – R/C 40014

EventSyncIn3Fall – Uint32 – R/C 40015

EventSyncIn4Rise – Uint32 – R/C 40016

EventSyncIn4Fall – Uint32 – R/C 40017

EventFrameTriggerReady – Uint32 – R/C 40018

EventOverflow – Uint32 – R/C 65534

Always on. Cannot be turned off with EventSelector or EventsEnable1. Event

occurs if camera event buffer overflows, i.e. if host is unable to process/send

acknowledgements for events as quickly as events are generated from cam-

era.

EventError – Uint32 – R/C 65535

Always on. Cannot be turned off with EventSelector or EventsEnable1. Event

should never occur, only returning in case of firmware failure requiring cam-

era repair.

AcquisitionStart [Default] AcquisitionEnd

FrameTrigger FrameTriggerReady

AcquisitionRecordTrigger ExposureEnd

PtpSyncLocked PtpSyncLost

SyncIn1Fall SyncIn1Rise

SyncIn2Fall SyncIn2Rise

SyncIn3Fall SyncIn3Rise

SyncIn4Fall SyncIn4Rise