Technical information

AVT GigE camera attributes

AVT GigE Camera and Driver Attributes V1.3.1

This document is a master document for all AVT GigE camera models and is NOT camera specific

The control and readout of all camera inputs and outputs. The number of inputs

and outputs is camera model dependent.

StatusLed1

Indicates status of LED1.

StatusLedInvert - Enum - R/W

Polarity applied to the status LED.

StatusLed1Mode - Enum - R/W

Determines the behavior of the StatusLed1.

StatusLedGpoLevels - Enum - R/W

Status LED levels in GPO mode.

Possible values: On, Off

Note



On: yellow LED

Off: green LED

GPO Configured to be a general purpose output, control of

which is assigned to StatusLedGpoLevels

AcquisitionTriggerReady Active once the camera has been recognized by the

host PC and is ready to start acquisition

FrameTriggerReady Becomes active when the camera is in a state that will

accept the next frame trigger

FrameTrigger This is the logic trigger signal inside of the camera. It

is initiated by an external trigger or software trigger

Exposing [Default] Exposure in progress

FrameReadout Becomes active at the start of frame readout

Imaging Exposing or frame readout. Active when the camera is

exposing or reading out frame data

Acquiring Becomes active at the start of acquisition

SyncIn1/2/3/4 External input SyncIn1/2/3/4

Strobe1 Source is strobe timing unit

CCDTemperatureOK Only for cameras that support this feature: indicates

if camera has reached the desired temperature value

Possible values: RegStatusLedLevels

Note



StatusLedInvert can invert these values.