Technical information

AVT GigE camera attributes

AVT GigE Camera and Driver Attributes V1.3.1

This document is a master document for all AVT GigE camera models and is NOT camera specific

SyncIn1

SyncIn1GlitchFilter – Uint32 – R/W

Ignores glitches on the SyncIn1 input line with pulse duration less than set

value. Units are approximately accurate to nanoseconds. Exact units are camera

model and input dependent.

SyncIn2/3/4

Analogous to SyncIn1.

SyncInLevels – Uint32 – R

A bit field, each bit corresponding to a specific SyncIn input. For example: 2

equals (0010) which means SyncIn2 is high and all other Sync input signals are

low.

SyncOut1

Controls the camera output 1. Can be used for synchronization with other cam-

eras/devices or general purpose outputs.

SyncOut1Invert – Enum – R/W

When enabled, reverses the polarity of the signal output by SyncOut1.

SyncOut1Mode – Enum – R/W

Determines the type of output defined by SyncOut1:

Range: [0 – 50000] Default: 0 Units: relative

Note



Setting this value increases latency of

FrameTrigger by same amount.

Possible values: On, Off Default: Off

GPO Configured to be a general purpose output, control

of which is assigned to SyncOutGpoLevels

AcquisitionTriggerReady Active once the camera has been recognized by the

host PC and is ready to start acquisition

FrameTriggerReady Active when the camera is in a state that will accept

the next frame trigger

Exposing Active for the duration of sensor exposure

FrameReadout Active during frame readout, i.e. the transferring of

image data from the CCD to camera memory

Imaging Active when the camera is exposing or reading out

frame data

Acquiring Active during an acquisition stream

SyncIn1 Active when there is an external trigger at SyncIn1

SyncIn2 Active when there is an external trigger at SyncIn2

SyncIn3 Active when there is an external trigger at SyncIn3