Specifications

Specifications

Goldeye Technical Manual V2.4.0

Specifications

Goldeye P-008 SWIR / Goldeye P-008 SWIR Cool

Note



Timing changes in this chapter are valid:

• starting SN 00102 (P-032)

• SN 00308 (P-008)

• For older versions: contact AVT Technical Support.

Caution



Surge

To avoid damage caused by surge, connect the camera to an

AC/DC power supply. Use a certified industrial power supply

that complies with common industrial standards. Make sure

the polarization of the power supply is correct.

During the camera start-up, inrush currents ≥ 4 A can occur for

20 ms. Use a sufficiently dimensioned power supply to avoid

damage to the camera.

For the DC signal, use cable lengths less than 30 m. Consider

that the voltage drop increases with the cable length.

AVT (or your local dealer) provides suitable power supplies:

http://www.alliedvisiontec.com/emea/products/

accessories.html

Feature Specification

Sensor InGaAs sensor, progressive scan; electronic full-frame shutter

Effective chip size 9.6 mm (H) x 7.68 mm (V)

Cell size 30 μm x 30 μm

Resolution (max.) 320 (H) x 256 (V) full resolution

320 (H) x 160 (V) reduced resolution

Lens mount C-Mount

Spectral response 900 nm to 1700 nm (SWIR)

Pixel format Mono12

Frame rate up to 118 fps full resolution

up to 186 fps reduced resolution

Exposure time 5 μs to 100 ms / 5 μs to 1 s

Table 3: Specification Goldeye P-008 SWIR / Goldeye P-008 SWIR Cool