Specifications

Specifications
Goldeye Technical Manual V2.4.0
18
Goldeye P-032 SWIR Cool / Goldeye P-032 SWIR
F-Mount Cool
Note

The warranty becomes void because of unauthorized tamper-
ing or any modifications not approved by the manufacturer.
Timing changes (frame rates and exposure time) in this chapter
are valid starting SN 00102 (Goldeye P-032) or SN 00308
(Goldeye P-008).
Caution

Surge
To avoid damage caused by surge, connect the camera to an
AC/DC power supply. Use a certified industrial power supply
that complies with common industrial standards. Make sure
the polarization of the power supply is correct.
During the camera start-up, inrush currents ≥ 4 A can occur for
20 ms. Use a sufficiently dimensioned power supply to avoid
damage to the camera.
For the DC signal, use cable lengths less than 30 m. Consider
that the voltage drop increases with the cable length.
AVT (or your local dealer) provides suitable power supplies:
http://www.alliedvisiontec.com/emea/products/
accessories.html
Feature Specification
Sensor InGaAs sensor, progressive scan; electronic full-frame shutter
Effective chip size 15.9 mm (H) x 12.7 mm (V)
Cell size 25 μm x 25 μm
Resolution (max.) 636 (H) x 508 (V)
Lens mount C-Mount (Goldeye P-032 SWIR Cool)
F-Mount (Goldeye P-032 SWIR F-Mount Cool)
Spectral response 900 nm to 1700 nm (SWIR)
Pixel format Mono12
Table 5: Specification Goldeye P-032 SWIR Cool / Goldeye P-032 SWIR F-Mount Cool