Specifications

Advanced parameters and commands
This chapter illustrates the advanced configuration of the Goldeye xy-... mod-
els.
Two-point correction (A, B, E, J, K, N)
To configure the two-point correction, use the following parameters:
The parameter E controls the operation mode of the two-point correction. The
following value assignments are valid:
Note

In most cases, the use of basic commands is sufficient.
In some cases you might need the following advanced
parameters and commands.
Parameter Description
A File number of the first correction image recorded at low
reference temperature
B File number of the first correction image recorded at high
reference temperature
E Two-point correction operating mode
J Set value of the correction image of the actual chosen correction
data set recorded at low reference
K Set value of the correction image of the actual chosen correction
data set recorded at high reference
N File number for the set values of all correction data sets
Table 31: Advanced parameters: two-point correction
Value Description
0 Deactivated
Data are passed through transparently.
1 Activated
Correction data A and B are used, with the set values
J and K of the actual correction memory page S.
2 Deactivated
Test mode: Correction data A are output as image data. (*)
3 Deactivated
Test mode: Correction data B are output as image data. (*)
Table 32: Parameter E: values