Technical information

GigE camera and driver features
GigE Camera and Drivers Features V3.0.0
33
This document is a master document for all Allied Vision GigE camera models and is NOT camera specific
LUTBitDepthIn [Integer] R/C
Bit depth of the input value of the LUT block.
LUTBitDepthOut [Integer] R/C
Bit depth of the output value of the LUT block.
LUTSizeBytes [Integer] R/C
Memory size of the active LUT.
LUTLoadAll / LUTLoad [Command]
Loads LUT from flash memory into volatile memory of the camera.
LUTMode [Enum] R/W
Selects on which pixels the selected LUT (depending on LUTSelector) will
be applied.
LUTSaveAll / LUTSave [Command]
Saves LUT from volatile memory into flash memory of the camera.
LUTSelector [Enum] R/W
Selects which look-up table is used. These LUTs are camera specific.
LUTValue [Integer] R/W
Returns or sets the value at entry LUTIndex.
Display name: LUTBitLengthIn
Display name: LUTBitLengthOut
Display name: LUTSize
Luminance [Default] LUT is applied on all pixels
Red LUT is applied on red pixels only
Green LUT is applied on green pixels only
Blue LUT is applied on blue pixels only
Note
To avoid confusion, especially with color cameras, we
recommend the following steps:
1. Configure the LUT modes.
2. Enable the LUT.
Note
With UserSets control (UserSetSave com-
mand) you cannot save the contents of the LUT.
Possible values: LUT1, LUT2, LUT3, LUT4, LUT5 Default: LUT1
Range: [0 – (2
LUTBitDepthOut
- 1)]
Default: 4095