Technical information

GigE camera and driver features
GigE Camera and Drivers Features V3.0.0
45
This document is a master document for all Allied Vision GigE camera models and is NOT camera specific
IO
The control and readout of all camera inputs and outputs. The number of inputs
and outputs is camera model dependent.
StatusLED
StatusLedLevels [Integer] R/W
Status led levels in GPO mode.
StatusLedPolarity [Enum] R/W
Polarity applied to the status led specified by StatusLedSelector.
StatusLedSelector [Enum] R/W
Select the status led to be controlled with StatusLedSource and Statu-
sLedPolarity.
StatusLedSource [Enum] R/W
Signal source of the status led specified by StatusLedSelector.
Range: [0–4294967296] Default: 0
Note

StatusLedPolarity can invert these values.
Possible values: Normal, Invert
Possible values: StatusLed1
GPO General purpose output
AcquisitionTriggerReady Active once the camera has been recognized by the host PC and is
ready to start acquisition
FrameTriggerReady Becomes active when the camera is in a state that will accept the
next frame trigger
FrameTrigger This is the logic trigger signal inside of the camera. It is initiated
by an external trigger or software trigger
Exposing [Default] Exposure in progress
FrameReadout Becomes active at the start of frame readout
Imaging Exposing or frame readout. Active when the camera is exposing or
reading out frame data
Acquiring Becomes active at the start of acquisition
LineIn1/2/3/4 External input Line1/2/3/4
CCDTemperatureOK Only for cameras that support this feature: indicates if camera has
reached the desired temperature value
Strobe1 Source is strobe timing unit