Technical information

GigE Camera and Drivers Features V3.0.0

GigE IR & scientific camera and driver features

This document is a master document for all Allied Vision GigE camera models and is NOT camera specific

ExposureMode [Enum] R/W

Control for exposure duration.

ExposureTime [Float] R/W

The sensor integration time.

RecorderPreEventCount [Integer] R/W

Valid when AcquisitionMode = Recorder. The number of frames

returned before the AcquisitionRecord trigger event, with Acquisi-

tionFrameCount minus RecorderPreEventCount frames being

returned after the AcquisitionRecord trigger event.

TriggerActivation [Enum] R/W

Type of activation, for hardware triggers. This controls edge/level and polarity

sensitivities.

TriggerDelay [Float] R/W

Start-of-image can be delayed to begin some time after a trigger event is

received by the camera. This feature is valid only when TriggerSource is

set to external trigger (i.e. Line1, Line2). This control is a common trigger

to sync with a strobe lighting source, which will inherently have some fixed

setup time.

TriggerMode [Enum] R/W

Enables or disables trigger set in TriggerSelector.

Timed [Default] The camera exposure time is set by ExposureTime

Range: [Camera dependent] Unit: µs

Range:[0 – 65535] Default: 0 Unit: Frames

Note



At least one image must be captured after the

AcquisitionRecord trigger event, i.e., you

cannot set RecorderPreEventCount = 1,

and AcquisitionFrameCount = 1.

RisingEdge [Default] Rising edge trigger

FallingEdge Falling edge trigger

AnyEdge Rising or falling edge

LevelHigh Active high signal

LevelLow Active low signal

Range:[0 – Camera dependent] Default: 0 Unit: µs

Off Trigger disabled

On [Default] Trigger enabled