Technical information

GigE Camera and Drivers Features V3.0.0
79
GigE IR & scientific camera and driver features
This document is a master document for all Allied Vision GigE camera models and is NOT camera specific
NUCDatasetAuto [Enum] R/W
Controls automatic selection of the NUCDatasetActive.
NUCDatasetDescription [String] R
Description of the data set indexed by NUCDatasetSelector.
NUCDatasetExposureTime [Float] R
Shows the exposure time at acquisition of the data set indexed by NUCData-
setSelector. The data set should be selected so that the actual exposure
time setting corresponds to the reference value.
NUCDatasetGain [Float] R
SensorGain setting at acquisition of the data set indexed by NUCData-
setSelector. The data set should be selected so that the actual sensor gain
setting corresponds to the reference value.
NUCDatasetNodeSelector [Integer] R/W
Selects a data point of a data set for access to its properties, starting at 0. The
maximum possible value depends on the number of valid data points in the data
set.
NUCDatasetNodeValue [Float] R
Shows the set value of the selected data point. Set point defines a mean value
which the corrected image will have if the input image has a mean value of the
corresponding correction data image.
NUCDatasetSelector [Integer] R/W
Selects a data set for access. The maximum possible value depends on the num-
ber of valid data sets in the camera. The mapping of an index value to a specific
correction data file may vary from camera to camera or after correction data
modifications.
Off [Default] The automatic mode is off
Once Auto-NUC occurs until target is achieved, then
NUCDatasetAuto returns to Off
Continuous The non-uniformity correction will continue
according to the scene illumination
0 SensorGain = LowGain
1 SensorGain = HighGain
Note

The number of distinct reference values is limited by available
correction data, depending on the camera variant.
Range: [0 – Camera dependent]
Values: [0 – Camera dependent] Default: Camera dependent