Technical information

AVT GigE camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

TriggerSelector [Enum] R/W

Selects a trigger, then use the controls {TriggerMode, TriggerSoft-

ware, TriggerSource, TriggerActivation, TriggerOverlap,

TriggerDelayAbs} to setup and read the trigger features.

TriggerSoftware [Command]

Triggers an image. Valid when TriggerSource = Software.

TriggerSource [Enum] R/W

Determines how an image frame is initiated within an acquisition stream.

BufferHandlingControl

StreamAnnounceBufferMinimum [Integer] R

For Vimba v1.3 or higher only Minimal number of buffers to announce to enable selected acquisition mode.

StreamAnnouncedBufferCount [Integer] R

For Vimba v1.3 or higher only Number of announced (known) buffers on this stream.

StreamBufferHandlingMode [Enum] R/W

For Vimba v1.3 or higher only Available buffer handling modes of this stream.

FrameStart [Default] The trigger which starts each image

(when acquisition is running)

AcquisitionStart The trigger which starts the acquisition process

AcquisitionEnd The trigger which ends the acquisition process

AcquisitionRecord The trigger which initiates the sending of recorded

images from the camera on-board memory to the

host

Note



An acquisition stream must be started in order to

trigger/receive individual frames. For Freerun

and FixedRate the first frame is synchronized

to AcquisitionStart trigger.

Freerun [Default] Camera runs at maximum supported frame rate

depending on the exposure time and region of interest size

Line1 External trigger Line1

Line2 External trigger Line2

Line3 External trigger Line3

Line4 External trigger Line4

FixedRate Camera self-triggers at a fixed frame rate defined by

AcquisitionFrameRateAbs

Software Software initiated image capture

Display name: Stream Announce Buffer Minimum

Display name: Stream Announced Buffer Count

Display name: Stream Buffer Handling Mode