Technical information

AVT GigE camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

GainAutoControl

GainAutoAdjustTol [Integer] R/W

Tolerance in variation from GainAutoTarget in which the auto exposure

algorithm will not respond. This feature is used to limit auto gain changes to

only larger variations in scene lighting.

GainAutoMax [Float] R/W

The upper bound to the gain setting in auto gain mode.

GainAutoMin [Float] R/W

The lower bound to the gain setting in auto gain mode.

GainAutoOutliers [Integer] R/W

The total pixels from top of the distribution that are ignored by the auto gain

algorithm.

GainAutoRate [Integer] R/W

The rate at which the auto gain function changes. A percentage of the maximum

rate.

GainAutoTarget [Integer] R/W

The general lightness or darkness of the auto gain feature. A percentage of max-

imum brightness.

GainRaw [Integer] R/W

Gain value of analog A/D stage.

GainSelector [Enum] R/W

Control for gain selection.

Gamma [Float] R/W

Nonlinear brightness control. Applies gamma value to the raw sensor signal

(via LUT).

Range: [0–50] Default: 5 Units: Percent

Range: [0 – Camera dependent] Units: dB

Range: [0 – Camera dependent] Default: 0 Units: dB

Range: [1–1000] Default: 0 Units: 0.01%, i.e. 1000 = 10%

Range: [0–100] Default: 100 Units: Percent

Range: [0–100] Default: 50 Units: Percent

Range: [Camera dependent] Default: 0 Units: dB

Possible value: All

Range: Camera dependent Default: 1.00

Units: Output = (Input)

Gamma

1.00 Gamma OFF (no Gamma correction)

Values other than 1.00 Gamma ON