Technical information

AVT GigE camera and driver features
AVT GigE Camera and Drivers Features V2.0.0
29
This document is a master document for all AVT GigE camera models and is NOT camera specific
LUTIndex [Integer] R/W
Controls the index (offset) of the coefficient to access in the selected LUT.
LUTInfo
This control provides information depending on LUTSelector.
LUTAddress [Integer] R/C
Indicates location of memory, when LUT is loaded.
LUTBitDepthIn [Integer] R/C
Bit depth of the input value of the look-up table block.
LUTBitDepthOut [Integer] R/C
Bit depth of the output value of the LUT block.
LUTSizeBytes [Integer] R/C
Size of the memory area where the LUT is located.
LUTLoad [Command]
Loads LUT from flash memory into volatile memory of the camera.
LUTMode [Enum] R/W
Selects on which pixels the selected LUT (depending on LUTSelector) will
be applied.
LUTSave [Command]
Saves LUT from volatile memory into flash memory of the camera.
LUTSelector [Enum] R/W
Selects which look-up table is used. These LUTs are camera specific.
Range: [0 – (2
LUTBitDepthIn
- 1)]
Default: 0
Display name: LUTBitLengthIn
Display name: LUTBitLengthOut
Display name: LUTSize
Luminance [Default] LUT is applied on all pixels
Red LUT is applied on red pixels only
Green LUT is applied on green pixels only
Blue LUT is applied on blue pixels only
Note

To avoid confusion, especially with color cameras, we
recommend the following steps:
1. Configure the LUT modes.
Note

With UserSets control (UserSetSave com-
mand) you cannot save the contents of the LUT.
Possible values: LUT1, LUT2, LUT3, LUT4, LUT5 Default: LUT1