Technical information

AVT GigE camera and driver features
AVT GigE Camera and Drivers Features V2.0.0
30
This document is a master document for all AVT GigE camera models and is NOT camera specific
LUTValue [Integer] R/W
Returns or sets the value at entry LUTIndex of the LUT selected by LUTSe-
lector.
NirMode [Enum] R/W
Select 3 different NIR modes. The modes differ in quantum efficiency, frame
rates, and anti-blooming characteristics
Saturation [Float] R/W
Alters color intensity. Only valid when using on-camera interpolated Pixel-
Formats.
SubstrateVoltage
VsubValue [Integer] R/W
CCD substrate voltage. Optimized at factory for each sensor.
Range: [0 – (2
LUTBitDepthOut
- 1)]
Default: 4095
Off [Default] NirMode set off. Acquire and readout image at same time.
NIR sensitivity: No increased sensitivity in NIR range
Anti-blooming characteristics: As specified by sensor manufacturer
Usage: Best suited if you need very long exposure time
On_HighQuality Cannot acquire and readout image at same time. The exposure time will always
influence frame rate directly.
NIR sensitivity:
Increased NIR sensitivity, except for a very small portion of the exposure time,
which is:
t
NormalQE
= MIN(4300 s, ExposureTimeAbs/4)
Anti-blooming characteristics:
• Very good if, ExposureAuto = Off
• Adaptively reduced if, ExposureTimeAbs < 13200 s or
ExposureAuto = Other
Usage: Best suited for medium length exposure times and high-dynamic range
(HDR) light conditions
On_Fast Acquire and readout image at same time.
NIR sensitivity: Increased NIR sensitivity during total exposure time
Anti-blooming characteristics: Reduced anti-blooming characteristics
Usage: Best suited for low-light applications and small exposure times, when
high frame rate is desired
Range: [0.00–2.00]
0.00 Monochrome
1.00 [Default] Default saturation
2.00 Maximum possible saturation that can be applied
Range: [Camera dependent] Units: mV