Technical information

AVT GigE camera and driver features
AVT GigE Camera and Drivers Features V2.0.0
34
This document is a master document for all AVT GigE camera models and is NOT camera specific
EventsEnable1 [Integer] R/W
Default: 0. Bit field of all events. For example:
This is an alternative to setting each event individually using the EventNo-
tification and EventSelector method.
GigE
BandwidthControlMode [Enum] R/W
Selects the desired mode of bandwidth control.
ChunkModeActive [Boolean] R/W
Enables camera to send GigE Vision Standard Protocol chunk data with an
image.
Currently implemented chunk data:
Bit 1 EventAcquisitionStart
Bit 2 EventAcquisitionEnd
Bit 3 EventFrameTrigger
Bit 19 EventFrameTriggerReady
StreamBytesPerSecond [Default] See the StreamBytesPerSec-
ond feature for more information
SCPD Stream channel packet delay expressed in
timestamp counter units. This mode may be
used to limit the rate of data from the camera
to the host. It works by inserting a delay
between successive stream channel packets,
e.g. the longer the delay, the slower the data
rate. This mode is NOT recommended
Both Implements a combination of control
modes.This mode is NOT recommended
Possible values: True, False Default: False
[Bytes 1 – 4] Acquisition count
[Byte 5]
These 8 bits indicate the following EF lens settings:
• Bit 7 (Error): When this bit is set to 1, the EF lens is in an error state, bits
2 – 5 indicate enumerated value of last error, and all other bits and
Bytes will be 0.
• Bit 6 (Lens attached): When this bit is set to 1, an EF lens is attached to
camera.
• Bit 5 (Auto focus): When this bit is set to 1, the EF lens manual/auto
focus switch is set to the auto focus position.