Technical information

AVT GigE IR & scientific camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

TriggerDelay [Float] R/W

Start-of-image can be delayed to begin some time after a trigger event is

received by the camera. This feature is valid only when TriggerSource is

set to external trigger (i.e. Line1, Line2). This control is a common trigger

to sync with a strobe lighting source, which will inherently have some fixed

setup time.

TriggerMode [Enum] R/W

Enables or disables trigger set in TriggerSelector.

TriggerOverlap [Enum] R/W

Permitted window of trigger activation, relative to previous frame. Does not

work with Software triggering. Only external.

TriggerSelector [Enum] R/W

Selects a trigger, then use the controls {TriggerMode, TriggerSoft-

ware, TriggerSource, TriggerActivation, TriggerOverlap,

TriggerDelay} to setup and read the trigger features.

TriggerSoftware [Command]

Triggers an image. Valid when TriggerSource = Software.

Range:[0 – Camera dependent] Default: 0 Units: µs

Off Trigger disabled

On [Default] Trigger enabled

Note



If TriggerMode = Off and TriggerSelector =

FrameStart, images triggered in FixedRate at

AcquisitionFrameRateAbs.

Off [Default] Any external trigger received before a high

FrameTriggerReady signal is ignored

PreviousFrame Any external trigger received before

FrameTriggerReady is latched and used to trigger

the next frame

FrameStart [Default] The trigger which starts each image

(when acquisition is running)

AcquisitionStart The trigger which starts the acquisition process

AcquisitionEnd The trigger which ends the acquisition process

AcquisitionRecord The trigger which initiates the sending of recorded

images from the camera on-board memory to the

host