Technical information

AVT GigE IR & scientific camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

SensorTemperatureSetpointValue [Float] R

The setpoint temperature, in °C, corresponding to the setpoint selected in

SensorTemperatureSetpointSelector.

TimestampLatch [Command]

Captures timestamp and stores in TimestampLatchValue.

TimestampLatchValue [Integer] R

Value of timestamp, when latched by TimestampLatch.

TimestampReset [Command]

Resets the camera’s timestamp to 0.

DigitalIOControl

LineIn

Signal source of the strobe timing unit. See LineOutSource for descrip-

tions.

LineInGlitchFilter [Integer] R/W

Ignores glitches on the LineIn input line with pulse duration less than set

value.

LineInLevels [Integer] R

A 4-bit register where each bit corresponds to a specific LineIn input. For exam-

ple, when this value returns 2 (0010), LineIn2 is high and all other Line input

signals are low.

LineInSelector [Enum] R/W

Select the LineIn to control with LineInGlitchFilter.

LineOut

Used for synchronization with other cameras/devices or general purpose out-

puts.

LineOutLevels [Integer] R/W

Output levels of hardware line outputs, for output(s) in GPO mode.

Units: Camera clock ticks

Range: [0–50000] Default: 0 Units: ns

Note



Setting LineInGlitchFilter value increases

latency of FrameTrigger by same amount.

Possible values: LineIn1, LineIn2, LineIn3, LineIn4 Default: LineIn1