Technical information

AVT GigE IR & scientific camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

NonUniformityCorrection

NUCDatasetActivate [Command]

Activates the data set that is currently indexed by the NUCDataSetSelec-

tor.

NUCDatasetActive [Integer] R

The index of the active data set, starting at 0. The maximum possible value

depends on the number of valid data sets in the camera. The mapping of an

index value to a specific correction data file may vary from camera to camera or

after correction data modifications. Use the NUCDatasetSelector and

corresponding features to retrieve more information about the data sets.

NUCDatasetAuto [Enum] R/W

Controls automatic selection of the NUCDatasetActive.

NUCDatasetDescription [String] R

This text corresponds to the file description in the file system of the camera.

NUCDatasetExposureTime [Float] R

Shows the exposure time at acquisition of the data set. The data set should be

selected so that the actual exposure time setting corresponds to the reference

value.

NUCDatasetGain [Float] R

SensorGain setting at acquisition of the data set. The data set should be

selected so that the actual sensor gain setting corresponds to the reference

value.

NUCDatasetNodeSelector [Integer] R/W

Selects a data point of a data set for access to its properties, starting at 0. The

maximum possible value depends on the number of valid data points in the data

set.

NUCDatasetNodeValue [Float] R

Shows the set value of the selected data point.

Range: [0 – Camera dependent]

Off [Default] The automatic mode is off

Once Auto-NUC occurs until target is achieved, then

NUCDatasetAuto returns to Off

Continuous The non-uniformity correction will continue

according to the scene illumination

0 SensorGain = LowGain

1 SensorGain = HighGain

Range: [0 – Camera dependent]