Technical information

AVT GigE IR & scientific camera and driver features

AVT GigE Camera and Drivers Features V2.0.0

This document is a master document for all AVT GigE camera models and is NOT camera specific

NUCDatasetSelector [Integer] R/W

Selects a data set for access. The maximum possible value depends on the num-

ber of valid data sets in the camera. The mapping of an index value to a specific

correction data file may vary from camera to camera or after correction data

modifications.

NUCDatasetTemperature [Float] R

Shows sensor temperature, in °C, at acquisition of the data set. The data set

should be selected so that the actual sensor temperature is close to the refer-

ence temperature.

NUCMode [Enum] R/W

Controls the operating mode of the non-uniformity correction. Depending on

the factory-provided correction data, different modes may be available.

ImageFormatControl

Height [Integer] R/W

Height of image.

HeightMax [Integer] R

Maximum image height for the current image mode.

ImageSize [Integer] R

Size of images, in bytes, for the current format and size.

OffsetX [Integer] R/W

Starting column of the readout region (relative to the first column of the sen-

sor) in pixels.

OffsetY [Integer] R/W

Starting row of the readout region (relative to the first row of the sensor) in pix-

els.

Values: [0 – Camera dependent] Default: Camera dependent

Off Non-uniformity correction is off

OnePoint Only one reference point is used for correction

TwoPoint [Default] Two reference points are used for correction

ThreePoint Three reference points are used for correction

Range: [Camera dependent] Units: Pixels

Range: [0 – Camera dependent] Default: 0 Units: Pixels