Technical information

AVT GigE IR & scientific camera and driver features
AVT GigE Camera and Drivers Features V2.0.0
80
This document is a master document for all AVT GigE camera models and is NOT camera specific
StatPacketMissed [Integer] R
The number of packets missed since the start of imaging.
StatPacketReceived [Integer] R
Indicates the number of packets received by the driver since the start of imag-
ing, this number should grow steadily during continuous acquisition.
StatPacketRequested [Integer] R
When an expected packet is not received by the driver, it is recognized as miss-
ing and the driver requests the camera to resend it. The resend mechanism
ensures very high data integrity.
StatPacketResent [Integer] R
The number of packets resent by the camera since the start of imaging.
StatTimeElapsed [Float] R
Elapsed time (in seconds) since the streaming was started.
TransportLayerControl
BandwidthControlMode [Enum] R/W
Selects the desired mode of bandwidth control. Bandwidth allocation can be
controlled by DeviceLinkThroughputLimit or by SCPD0 register. If you
are not familiar with SCPD0 and how this driver uses this register, leave this fea-
ture set to DeviceLinkThroughputLimit.
Display name: Stat Packets Missed
Note

If everything is configured correctly, this number
should remain zero, or at least very low compared
to StatPacketReceived.
Display name: Stat Packets Received
Display name: Stat Packets Requested
Note

If everything is configured correctly, this number
should remain zero, or at least very low compared
to StatPacketReceived.
Display name: Stat Packets Resent
Display name: Stat Time Elapsed
DeviceLinkThroughputLimit [Default] See the DeviceLinkThroughputLimit feature
for more information
SCPD Stream channel packet delay expressed in timestamp counter
units. This mode may be used to limit the rate of data from the
camera to the host. It works by inserting a delay between
successive stream channel packets; for example, the longer the
delay, the slower the data rate. This mode is NOT recommended
Both Implements a combination of control modes.This mode is NOT
recommended