Owner's manual

Specifications
Bigeye G Technical Manual V2.1.0
29
Features
Exposure time 1394 μs … 4294.97 s in 1 μs increments
Binning 1x2, 2x1, 2x2
Gain 0, +6 dB
Gamma 0.45, 0.5, 0.7
ROI available (Note: decreasing ROI does not increase frame rate)
Video-type auto iris available
Trigger modes Continuous mode (image acquisition with maximum frame rate)
IOD mode (Image on Demand: triggered image acquisition)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 102.26 seconds in 1 μs increments
Fixed rate control 0.000233 fps to max. frame rate
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe,
GPO, CCDTemperatureOK
Internal image memory 32 MByte, up to 3 frames
Interfaces
Digital interface IEEE 802.3 1000BASE-T (GigE Vision V1.2 compliant)
GigE connector RJ45 (8P8C) with horizontal screw-locks
I/O port connector 20-pin Mini D Ribbon (MDR) shielded I/O connector with screw-locks
Camera control interface GenICam V1.0 compliant
I/O 4 inputs (3 optocoupled)
4 outputs (3 optocoupled)
Operating conditions
Operating temperature 0 °C to +35 °C ambient temperature (without condensation)
Stabilized cooling
temperature
0 °C (Peltier cooling)
(up to +25 °C ambient temperature)
Power requirements +12 V (+5 %), max. 3 A (during camera start-up: inrush current
≥ 4 A for 20 ms, capacitive load < 2000 μF)
Power consumption Max. 36 watts
Typical 18 watts (@ 12 V DC)
(maximal frame rates at full resolution)
Feature Specification
Table 6: Specification Bigeye G-1100B Cool
Note

The number of frames (StreamHoldCapacity) depends on
resolution and pixel format. Listed number of frames is
typical for full resolution and Mono8.