Owner's manual

Parameters and commands

Bonito Technical Manual V2.3.0

Related Parameters A, B, D, and N

Example I=4 output every 4

line

N=1AF (0x1AF = 431), sets number of lines to 431, which equals a quarter

of the full image

Synchronization output (J)

Parameter J sends an output synchronization signal to pin 6 of the camera con-

trol connector.

Valid values: Either one of the values 0, 1, 2, 3, 8, 9, A, B

Default 1

Related Parameters D, E, F, M, N and S

Setting Output signal

J=0 Effective sensor exposure

J=1

Charge transfer pulse

Active for one line duration at the end of exposure. End of this

pulse marks the end of exposure and at the same time start of sen-

sor readout.

In PIV mode: this pulse occurs at the exposure end of only the first

image of each PIV pair. For more information see chapter PIV

mode (bit group p) on page 51

J=2 Effective sensor readout

J=3

Exposure phase

Contrary to J=0, this setting shows the exposure phase of the

internal state machine and not the effective exposure of the sen-

sor. This allows to synchronize external devices even if the sensor

is in permanent exposure mode. For more details see chapter

Exposure control mode (M) on page 45.

J=8 Same as J=0, but with inverted logic on sync output

J=9 Same as J=1, but with inverted logic on sync output

J=A Same as J=2, but with inverted logic on sync output

J=B Same as J=3, but with inverted logic on sync output

Table 7: Synchronization output