Owner's manual

Parameters and commands

Bonito Technical Manual V2.3.0

Bonito CMOS High-Speed Camera

Version: CMC.040.xx.yy

Save parameters (X)

Use the command X=1 to store all parameter values into the embedded flash

memory. After a re-start they are automatically restored.

Parameter summary (Y)

The command Y shows a summary of all current parameter value settings.

Reset to factory defaults (Z)

The command Z=1 sets the camera into a factory default state. To save the new

parameter configuration, the command X=1 has to be executed afterwards.

The default settings are:

A=0000

B=0000

C=00

D=00

E=000006BE

F=000006BF

G=00

I=01

J=01

K=A7

M=00

N=06BD

S=00

Note



Acquired FPN correction data is not stored and is, therefore,

lost after switch-off.

See chapter Fixed pattern noise (FPN) correction (C) on page

39.