Owner's manual

Parameters and commands

Bonito Technical Manual V2.3.0

To set a sub-field to a certain value, modify the associated bit group by allocat-

ing s to the appropriate hexadecimal number.

Since all of the sub-fields are set using the parameter s, it is only possible to set

all of them at the same time. The value of s is calculated as the aggregate sum

of the hexadecimal values that are set to each of the three sub-fields.

The table below shows the hexadecimal values that can be set for each sub-

field. To work out the final value for s, select the usage for each sub-field, then

add the corresponding hexadecimal values.

FEDCBA9876543210

--------eaa-xxxx

- - - - - - - - rw rw rw rw rw rw rw

Table 27: Order of bit groups within parameter s

Bit values Settings Weight

(hexadecimal)

Baud rate of the serial ports

xxx-0000 110 Baud * 0

xxx-0001 300 Baud * 1

xxx-0010 600 Baud * 2

xxx-0011 1,200 Baud * 3

xxx-0100 2,400 Baud * 4

xxx-0101 4,800 Baud * 5

* Baud rates up to 4,800 Baud are not available via Camera Link.

xxx-0110 9,600 Baud 6

xxx-0111 19,200 Baud 7

xxx-1000 38,400 Baud 8

xxx-1001 57,600 Baud 9

xxx-1010 115,200 Baud A

Enable state of the serial ports

x00-xxxx RS232 via 15-pin D-sub connector only. 0

x01-xxxx Additionally activates second channel via

Camera Link connector O2.

x10-xxxx Additionally activates second channel via

Camera Link connector O4.

x11-xxxx

Additionally activates second channel via

Camera Link connector O2 and O4.

Table 28: Baud rate: hexadecimal weights for each setting