Owner's manual

Introduction
Bonito Technical Manual V2.3.0
7
continued from previous page
V2.2.0
(continued)
03.05.12
(continued)
•chapter Power supply (pin 1-4) on page 25
• Pin 6 changed from Reserve to Sync:
see chapter Camera I/O connector pin assignment (15-pin
D-sub connector) on page 25
•chapter Synchronization output (pin 6) on page 26
• In chapter Exposure output (pin 12-13) on page 27: added
Note This output is not recommended for new system
designs. on page 28
• Added chapter Synchronization output (J) on page 44
• Updated the following chapter to new bit field order:
chapter Exposure control mode (M) on page 45
• Range from N=0 (not N=1) in chapter Number of lines (N) on
page 58
• Added values 5 and 7 in chapter Camera Link output mode
setting (S) on page 60
• In chapter Reset to factory defaults (Z) on page 64:
Corrected E=000006BE (not 000006C1),
F=000006BF (not 000006C2)
Inserted J=01 and S=00
• Added new command reference description in chapter
Command reference on page 70
• Added hyperlink to AVT website for DeviceConfig in chapter
Serial I/O on page 22
• Changed AOI to ROI in the whole manual
V2.2.1 11 May 2012 • Some minor corrections
• Added 80 bit to Camera Link Full+
–chapter Bonito CL-400B/C, Bonito CL-400B/C 200fps on
page 13
• Added 80 bit to clearly describe the 10-tap configuration of
the Camera Link standard:
–chapter Camera Link interface (01-04 or CL1, CL2) on
page 29
–chapter Camera link connectors and 10-tap pin assign-
ment on page 29
to be continued on next page
Version Date Remarks
Table 1: Document history