Instruction manual

Prosilica GC Technical Manual V2.1.0
50
Camera interfaces
Camera I/O connector pin assignment
The general purpose I/O port uses a Hirose HR10A-10R-12PB connector on the
camera side. The mating cable connector is Hirose HR10A-10P-12S.
Figure 35: Camera I/O connector pin assignment
Note

The cable side Hirose connector is available for
purchase from Allied Vision.
P/N: K7600040 or 02-7002A
Pin Signal Direction Level Description
1 Camera GND In GND for ext. power Ground for camera power
supply
2 Camera Power In 5–16* VDC Camera power supply
3In 1 In U
in
(high) = 5–24 V
U
in
(low) = 0–0.8 V
Input 1 opto-isolated
(SyncIn1)
4 Out 1 Out Open emitter max.
20 mA
Output 1 opto-isolated
(SyncOut1)
5 Isolated IO
GND
In/Out Common GND for
In/Out
Isolated input and output
signal ground
6 Video iris Out --- PWM signal for iris control
7 Reserved --- --- ---
8 TxD RS-232 Out RS-232 Terminal transmit data
9 RxD RS-232 In RS-232 Terminal receive data
10 Signal GND --- --- Ground for RS232 and non-
isolated IO
11 In 2 In LVTTL max. 3.3 V Input 2 non-isolated (SyncIn2)
12 Out 2 Out LVTTL max. 3.3 V Output 2 non-isolated
(SyncOut2)
*Some models offer 5-25 VDC. See Camera power section for details.
1 9
8
7
6
5
4
3
2
11 12
10