Instruction Manual

Goldeye Technical Manual V2.5.0

Advanced parameters and commands

This chapter illustrates the advanced configuration of the Goldeye xy-... mod-

els.

Two-point correction (A, B, E, J, K, N)

To configure the two-point correction, use the following parameters:

The parameter E controls the operation mode of the two-point correction. The

following value assignments are valid:

Note



In most cases, the use of basic commands is sufficient.

In some cases you might need the following advanced

parameters and commands.

Parameter Description

A File number of the first correction image recorded at low

reference temperature

B File number of the first correction image recorded at high

reference temperature

E Two-point correction operating mode

J Set value of the correction image of the actual chosen correction

data set recorded at low reference

K Set value of the correction image of the actual chosen correction

data set recorded at high reference

N File number for the set values of all correction data sets

Table 32: Advanced parameters: two-point correction

Value Description

0 Deactivated

Data are passed through transparently.

1 Activated

Correction data A and B are used, with the set values

J and K of the actual correction memory page S.

Table 33: Parameter E: values