Manual

Configuration of the camera
GUPPY Technical Manual V7.1.0
267
Note

The BitsPerValue field indicates how many bits are read from
the LUT for any gray-value read from the sensor. To determine
the number of bytes occupied for each gray-value round-up
the BitsPerValue field to the next byte boundary.
Examples:
• BitsPerValue = 8  1 byte per gray-value
• BitsPerValue = 14  2 byte per gray-value
Divide MaxLutSize by the number of bytes per gray-value in
order to get the number of bits read from the sensor.
Note

Guppy cameras have the gamma feature implemented via a
built-in look-up table. Therefore you can not use gamma and
your own look-up table at the same time. Nevertheless you
may combine a gamma look-up table into your own look-up
table.
Note

When using the LUT feature and the gamma feature pay
attention to the following:
•gamma ON  look-up table is switched ON also
• gamma OFF  look-up table is switched OFF also
• look-up table OFF  gamma is switched OFF also
• look-up table ON  gamma is switched OFF