User Manual

Introduction
FireWire Hardware Installation Guide V8.0.0
12
Manual overview
The manual overview describes each chapter of this manual shortly.
•Chapter Contacting Allied Vision Technologies on page 6 lists AVT contact
data for both: technical information / ordering and commercial informa-
tion.
•Chapter Introduction on page 7 (this chapter) gives you the document his-
tory, a manual overview and conventions used in this manual (styles and
symbols). Furthermore you learn how to get more information on AVT
accessories, available AVT software and the AVT Technical Manuals.
•Chapter Safety instructions on page 17 describes safety instructions for
AVT cameras in general and special safety instructions for camera fami-
lies/models.
– Read this chapter carefully before operating any AVT camera.
continued from last page
V7.0.9 04.04.11 • Added Guppy PRO: Changing filter instructions same as
Marlin/Stingray: see Chapter Marlin/Stingray/Guppy PRO:
changing filters safety instructions on page 21 and Table 4:
How to remove the filter/protection glass on page 28
• Added Singapore: see Contacting Allied Vision
Technologies on page 6
• Revised camera delay descriptions:
Chapter Stingray delay on page 51
Chapter Pike delay on page 60
Chapter Guppy PRO delay on page 67
Chapter Guppy delay on page 74
Chapter Marlin delay on page 80
Chapter Oscar delay on page 86
V8.0.0 13.08.12 Added Guppy PRO F-033, Guppy PRO F-046, and Guppy PRO F-
095C
•Chapter Guppy PRO input block diagram on page 63
•Chapter Guppy PRO delay and minimum pulse width on page
64
•Chapter Guppy PRO block diagram on page 65
•Chapter Guppy PRO delay on page 67
Changed Pike trigger input voltage
• Pike trigger input voltage (GPIn1 and GPIn2) changed from
2 V to 3 V at min. input current of 5 mA, see Chapter Pike
camera I/O connector pin assignment on page 54.
Version Date Remarks
Table 1: Document history