Instruction manual

Guppy Technical ManualV7.4.0
18
Introduction
continued from previous page
V7.1.0
[continued]
07.05.2009
[continued]
[continued]
Offset of low noise binning mode changed from 0xF1000580 to
0xF10005B0 in Table 127: Advanced register: Low noise binning
mode on page 256.
Changed Camera In 1 signal U
in
(high) from 2 V to 2.4 V in Figure
28: Guppy (housing): Camera I/O connector pin assignment on
page 59
Corrected HUE and SATURATION in Feature control register to
Always 0 (for b/w and color cameras) on page 225 (TestTrack
Defect 605)
Calculated effective chip size for all sensors (with resolution of
Format_7 Mode_0) in Chapter Specifications on page 27
Due to discontinuation: removed Guppy F-025/029 cameras in
•Chapter Guppy cameras on page 25
•Chapter Conformity on page 26
•Chapter Specifications on page 27
•Chapter Video formats, modes and bandwidth on page 164
•Chapter Description of the data path on page 75
•Chapter Controlling image capture on page 141
Corrected drawing in Figure 113: Delayed integration timing on
page 245
V7.1.1 23.02.2010 Minor corrections:
• Corrected registers for IO_OUTP_PWM2/3/4 in Table 30:
PWM configuration registers on page 81 and in Table 103:
Advanced registers summary on page 228
• Revised Chapter Conformity on page 26.
• Corrected Guppy F-503 Format_7 Mode_4 to Mode_6: These
are sub-sampling modes: Table 74: Video formats Guppy F-
503B / Guppy F-503C on page 172
• Corrected Camera Input 1: U
in
(high) = 3.8 V...5 V
U
in
(low) = 0 V...1 V in Figure 28: Guppy (housing): Camera
I/O connector pin assignment on page 59
• Corrected: Board level cameras have also Input_2 ...
Input_4/Output_4 in Register 0xF1000044 on page 234
• Corrected: Defect pixel correction: Mono8 for b/w and Raw8
for color cameras: see Chapter Building defect pixel data on
page 110
to be continued on next page
Version Date Remarks
Table 1: Document history