Instruction manual

Guppy Technical ManualV7.4.0
245
Configuration of the camera
Input/output pin control
All input and output signals running over the HIROSE plug are controlled by this
register.
Delayed Integration Enable (IntEna)
A delay time between initiating exposure on the sensor and the activation edge
of the IntEna signal can be set using this register. The on/off flag activates/
deactivates integration delay. The time can be set in μs in DelayTime.
Note

• See Chapter Inputs on page 62.
• See Table 18: Input configuration register on page 62.
• See Table 19: Input routing on page 63.
• See Chapter IO_OUTP_CTRL 1-3 on page 68.
Note

• Only one edge is delayed.
•If IntEna_Out is used to control an exposure, it is possi-
ble to have a variation in brightness or to precisely time a
flash.
Figure 113: Delayed integration timing