Instruction manual

Guppy Technical ManualV7.4.0
27
Specifications
Specifications
Guppy F-033B/C
Note

• For information on bit/pixel and byte/pixel for each color
mode see Table 84: ByteDepth on page 193.
• Maximum protrusion means the distance from lens
flange to the glass filter in the camera.
Feature Specification
Image device Type 1/3 (diag. 6 mm) progressive scan SONY IT CCD ICX424AL/AQ w HAD microlens
Effective chip size 4.9 mm x 3.7 mm
Cell size 7.4 μm x 7.4 μm
Lens mount C-Mount: 17.526 mm (in air), Ø 25.4 mm (32 tpi), mechanical flange back to filter
distance: 9.5 mm
(see Figure 24: Guppy C-Mount dimensions on page 53)
CS-Mount: 12.526 mm (in air), Ø 25.4 mm (32 tpi), mechanical flange back dis-
tance: 8 mm
(see Figure 25: Guppy CS-Mount dimensions on page 54)
Picture size (max.) 656 x 494 pixels (Format_7 Mode_0)
ADC 10 bit
Frame rates 3.75 fps; 7.5 fps; 15 fps; 30 fps; 60 fps
variable frame rates in Format_7 up to 58 fps
Gain control Manual: 0-24 dB (0.035 dB/step); auto gain (select. AOI)
Shutter speed 129 μs … 67,108,864 μs (~67s); auto shutter (select. AOI)
External trigger shutter Trigger_Mode_0, Trigger_Mode_1, advanced feature: Trigger_Mode_15 (bulk);
trigger delay
Look-up table One, user programmable (10 bit  8 bit); gamma (0.5)
Smart functions • AGC (auto gain control), AEC (auto exposure control), LUT (look-up table)
only color: AWB (auto white balance)
• one configurable input, three configurable outputs, RS-232 port (serial port,
IIDC V1.31)
Transfer rate 100 Mbit/s, 200 Mbit/s, 400 Mbit/s
Digital interface IEEE 1394a IIDC V1.3, single port
Power requirements DC 8 V - 36 V via IEEE 1394 cable or 8-pin HIROSE
Power consumption Less than 2 watt (@ 12 V DC)
Table 3: Specification Guppy F-033B/C