Instruction manual

Guppy Technical ManualV7.4.0
59
Camera interfaces
Camera I/O connector pin assignment
Guppy (housing)
Figure 28: Guppy (housing): Camera I/O connector pin assignment
Note

GP = General Purpose
For a detailed description of the I/O connector and its operat-
ing instructions see the 1394 Installation Manual, Chapter
Guppy input description.
Read all Notes and Cautions in the 1394 Installation Manual,
before using the I/O connector.
www

For more information on cables and on ordering cables
online (by clicking the article and sending an inquiry) go to:
http://www.alliedvision.com/en/contact
Pin Signal Direction Level Description
1 Camera Out 1 Out U
out
(high) = 2.4 V...5 V
U
out
(low) = 0 V...0.4 V
Camera Output 1
(GPOut1)
default: IntEna
2 Camera Out 2 Out U
out
(high) = 2.4 V...5 V
U
out
(low) = 0 V...0.4 V
Camera Output 2
(GPOut2)
default: -
3 Camera Out 3 Out U
out
(high) = 2.4 V...5 V
U
out
(low) = 0 V...0.4 V
Camera Output 3
(GPOut3)
default: Busy
4 Camera In 1 In U
in
(high) = 3.8 V...5 V
U
in
(low) = 0 V...1 V
Camera Input 1
(GPIn1)
default: Trigger
5 RxD RS232 In RS232 Terminal Receive Data
6 TxD RS232 Out RS232 Terminal Transmit Data
7 External Power +8 ... +36 V DC Power supply
8 External GND GND for RS232, GPIOs
and ext. power
External Ground for RS232,
GPIOs and external power
1
3
4
6
7
8
5
2