Instruction manual

Guppy Technical ManualV7.4.0
69
Camera interfaces
The Polarity setting refers to the input side of the inverting driver.
See also Chapter Jitter at start of exposure on page 162.
Offsets are camera specific. For more information read Chapter Exposure time
offset on page 156.
0x06 FrameValid
0x07 Busy
Output 2
0x08 Follow corresponding input
(Inp1  Out1)
0x0A..0x1F Reserved
Note

The output mode 0x08 is not available for output pins directly
tied to an input pin.
Figure 32: Output impulse diagram
ID Mode Default
Table 25: Output routing
External Trigger Input, falling edge
Integration_Enable (IntEna)
IntEna delayed
Frame_Valid (Fval)
Busy
Delay set by register Trigger_Delay
+ offset
Delay set by register
IntEna_Delay
Trigger_Mode_0