Instruction manual
Guppy PRO Technical ManualV4.1.0
213
Configuration of the camera
Camera status
This register allows to determine the current status of the camera. The most
important flag is the Idle flag.
If the Idle flag is set the camera does not capture and does not send any images.
The ExSyncArmed flag indicates that the camera is set up for external triggering.
Even if the camera is waiting for an external trigger event the Idle flag might get
set.
Other bits in this register might be set or toggled: just ignore these bits.
0xF1000048 ADV_INQ_3 Camera Status [0]
Max IsoSize [1]
Paramupd_Timing [2]
F7 mode mapping [3]
Auto Shutter [4]
Auto Gain [5]
Auto FNC AOI [6]
--- [7..11] Reserved
Defect Pixel Correction [12]
--- [13..31] Reserved
0xF100004C ADV_INQ_4 --- [0]
--- [1]
--- [2]
--- [18..31] Reserved
Note
• Excessive polling of this register may slow down the
operation of the camera. Therefore, the time between
two polls of the status register should not be less than 5
ms. If the time between two read accesses is less than 5
ms the response will be delayed.
• Depending on shutter and isochronous settings the sta-
tus flags might be set for a very short time; thus, will not
be recognized by your application.
Register Name Field Bit Description
Table 128: Advanced register: Advanced feature inquiry